starter motor for 86 pajero 2.5L desiel.

lincooln · Post by **lincooln** » Wed Jul 25, 2007 8:16 pm

we have a starter motor that was recently fixed due to the fact it would just click and not turn over. it worked solidly for a couple of weeks then only worked some times then not at all. i was just wondering if this is the solenoid or the actual starter motor? and advice on hoe to get this fixed as we need it for transport on the farm and we i need it for some trials. the engine is in very good nick starts easily.

WACKO · Post by **WACKO** » Thu Jul 26, 2007 2:09 pm

not sure what the problem is, but if its the same as the gen 2 starter motors i have one for sale...

rangimotors · Post by **rangimotors** » Thu Jul 26, 2007 2:11 pm

use a hammer! if it doen't work get a bigger hammer

philux · Post by **philux** » Thu Jul 26, 2007 6:05 pm

I had the same problem just last weekend, hammer worked for a bit then it fucked out completly, Took the starter motor to bits and on closer inspection i found shit loads of black carbony/ burnt crud. and also the windings had burnt out/melted appart. [/img]

Post by **SV1K** » Thu Jul 26, 2007 6:12 pm

Most of the time it will be the starter box's, they are located by the front left light. I had so many problems with my old one that I just by-passed the whole lot and put a push button on the dash, never had a problem after than.

I also have a few starter motor's that are for sale for 2.4 TD pajero's. Let me know if you need any help or more information and I will do me best to help.

lincooln · Post by **lincooln** » Thu Jul 26, 2007 8:47 pm

yea thanks for the advice. Unfortuantely a hammer don't work neither does a bigger one. i have been told it may be the solenoid. I don't know if this is likely or not. we tried shorting the solenoid and it worked a few times but then gave up on me. still roll starts fine. if any of you guys have prices for starters I'm interested or any more info on them.

WACKO · Post by **WACKO** » Fri Jul 27, 2007 2:08 pm

you can have mine for $30 but its in welly. im not sure on freight either. then there is the state of the garage and the fact that im in oz so my flatmate will have to find it.... then the issue of it fitting.... :lol:

lincooln · Post by **lincooln** » Fri Jul 27, 2007 4:55 pm

WACKO wrote:you can have mine for $30 but its in welly. im not sure on freight either. then there is the state of the garage and the fact that im in oz so my flatmate will have to find it.... then the issue of it fitting....

yea hey im up in the north shore. what condition is your starter in?