[b]Yet another newcomer[/b]

[DJ]

what if you weld it there?? in other word bolt it weld it and put extra support??

please don't weld a tow hook as its made from cast steel or dropped forged ( not 100% sure but it doesn't matter which one )and they don't to kindly to a home welder tiring to save a dollar.and you are in deep doggie poo when you have to replace it. Tow hooks are supplied new with rated hi-tensile bolts just for you to use.
With all the messing around its far easier to mount the hook/s to the chassis . Most surfs have the mounting holes already. I have put a 5mm plate inside the chassis rail and bolted up through this and the chassis. By removing the tow bar increases the departure angle and I'm not too keen about towing a trailer around the bush thru mud holes.
TWL have tow hooks on special for about $15 + GST comes with spring clip and BOLTS /nuts etc. or Ill sell them to ya at $20.+

[DJ]

Yea Yea Yea I know thanks Mr Thread jacking policeman I have moved on to my on little world with a new title Jacking police never sleeps

[lanky]

hi again guys, 1st chance to get near a pc, thanks for all the help.

Problem is the chassis rails are tucked way up under the body making it impossible to get to without climbing right under the car. Have talked to loads of ppl bout it and the best anyone has come up with is mounting it to one of the side brackets, and im not all that keen on that.

Would be great if anyone out there with a ln130 surf has properly mounted hooks on the back and could give some advice or pics, thanks again every1 u guys are awesome!

[niblik]

thought about mounting em onto a rear bar? what sorta rear bar ya got?

just ask, lads will post pics of their set ups...

be the easiest way rather than tryin to attach to the chassis rails..

good luck with the hunt.. seek, yee shall find!

[lanky]

yea have been looking heaps onhere still havent found much, only has factory flimsy chrome bumper...

[niblik]

have a looky in here....

http://www.offroadexpress.co.nz/modules ... A+rear+bar

hope it gives ya an idea or some inspiration..

[Smurf]

KZN130, rear bumper removed. The rear bar is my original rear bar from my old LN61


Rear of my YN60, shares pretty much the same chassis rails in the rear as LN61/130 etc

Both trucks have a 50mm body lift

[lanky]

all looks pretty good, apart from the fact that i cant weld

[radar21]

what would a rear bar like that cost to get mad

[surf_tomo]

I have a LN130 as well and not yet mounted tow hook on back as ive only recently bought my truck

Helpfull forum cheers

[Smurf]

I made/modified my bars so can't give a price, but I would think $350 at an engineers would get you there though. Supralux may be able to give you a better ballpark figure