Offroad-Express

Love it

PR wrote:Bubbles Pajero

i have a matching dent in my drivers door!

http://www.mitsubishi-motors.co.nz/vehicles/utes/4wd_triton_diesel/glx_dcw/

in red, with canopy. pick it up next week when the truck delivers it to Dunedin for me.

the deck size is good for a double cab,did reliese they were that size, very useable

callum007 wrote:http://www.mitsubishi-motors.co.nz/vehicles/utes/4wd_triton_diesel/glx_dcw/

in red, with canopy. pick it up next week when the truck delivers it to Dunedin for me.

Hope you didn't get a factory canopy, they are no where near water proof and the locks crap out real quick. My old boss got one which i drove around quite a bit, didn't like the auto one bit, neither did the 4wd mag that tested them towing.

The New Improved Paj, This is how toyota should have made these diffs, Wider upside down and under a paj

home made white walls from previous owner (curb surfing)




[img]http://sphotos.ak.fbcdn.net/hphotos-ak-snc3/hs521.snc3/29660_390528459623_622709623_4058083_1951654_n.jpg
[/img]



would you like to upsize your paj combo?

Now with 36s

my stock as (for now) series 1

will post when i get my new tyres

hoping to get new springs soon but wof is next in line hahaha

Well here is my L200.....



But it's now for sale
I want another Samurai

My Mum's LWB

Better put me shiney in here. Used to get down the beach, shiney trips, Boat launching - once I replace the old waka, and to give anyone else in the Manukau Club towing practice ........

WACKO wrote:newish photo of mine....(the green jtop)




now just gota find the $$ for 35s and make up a front bar.

Sam

Dam, nice tuck. 35's should fit easy as.

just sold the rover bought 96 paj 2.8td for $1 of my boss he has owned since imported at 15k on the clock it got the the jaos bash plates underneth got new set of 31inch pirelli mud scorpion tyres and wna find the gangsta yellow cibie lights it wired for. engine done 240k but 70k on rebuilt engine an the 4wd has never been used but the front wheel drive lights behind dash have blown went to pik a part an got new bulbs an front wheel drive lights are flashing anyone know what this means? it is vacuum operated 4x4? any info where i can find out what the chassis codes mean? will get some photos up soon very happy not puting $220 of premium into the rover now. will have to go thompsons soon now that i can afford to

Photos compulsory in this thread!

Flashing lights:
http://lmgtfy.com/?q=pajero+flashing+lights+fix

pjb wrote:Flashing lights:
http://lmgtfy.com/?q=pajero+flashing+lights+fix

not bad for a buck put it up on stands an the 4wd works but the lights keep on flashing when disengaged and no it dont have a lsd in the rear and found a split cv boot so no mud yet but got to spend the day changing every belt fluid an filter still need those gangsta yellow cibie lights any out there?

my 89 pajero

my 92 swb project, 2.8L turbo diesel, manual.

I got bored....

I'll play



Before I did anything to it (the one the right way up )

hopefully the link worked...got this cheap so plan is for Tu's to 4 link rear and 5 link front.im gonna chuck a 1kzte in it aswell

muddyplumber wrote: hopefully the link worked...got this cheap so plan is for Tu's to 4 link rear and 5 link front.im gonna chuck a 1kzte in it aswell

Looks good. (for a mitsi..) I like it.

Haha yea won't be much Mitzi in it when iv finished with it

muddyplumber wrote:Haha yea won't be much Mitzi in it when iv finished with it

Will you actually finish this one?

Looks good though be good to go out again once its ready.

F u jase course it won't be jokes dont have any plans on selling it.got it cheap and with recovery gear and high lift jack etc so can't complain.yea will plan a trip,last one was mean.Rich

my old series1...few mods here and there