Page 1 of 1
BJ40 wont turn off
Posted: Sun Mar 30, 2008 4:31 pm
by tangy
Hey all, just brought a Bj40 and it wont turn off, im having to stall the truck to make it. Any suggestions on what it might be? thanks
Im a newbie, first FWD.
cheers.
Re: BJ40 wont turn off
Posted: Sun Mar 30, 2008 5:04 pm
by rayndeb
they have an edic device that shuts off the fuel flow to the engine..sounds like it is faulty..it works a metal rod to the injector pump it should move the rod when you shut it off..does that make sense..
Check this out
http://forum.ih8mud.com/diesel-tech-24- ... hingy.htmlI just asumed its a 3b being a bj40
Re: BJ40 wont turn off
Posted: Sun Mar 30, 2008 5:46 pm
by tangy
yup found it, the rod is stiff. i can move the rod to turn the truck off with a little bit of force, is ther a way to adjust it somehow to make it work ?
rayndeb wrote:they have an edic device that shuts off the fuel flow to the engine..sounds like it is faulty..it works a metal rod to the injector pump it should move the rod when you shut it off..does that make sense..
Check this out
http://forum.ih8mud.com/diesel-tech-24- ... hingy.htmlI just asumed its a 3b being a bj40
Re: BJ40 wont turn off
Posted: Sun Mar 30, 2008 6:00 pm
by rayndeb
they have to move three ways fully forward middle and back i would try to disconnect the rod from the solenoid unit and see if its the rod or the unit then go from there .. if its the rod i would just try to lube it up with crc or somethig similar if its the unit i dont know
Re: BJ40 wont turn off
Posted: Thu Apr 03, 2008 2:58 pm
by rayndeb
how did you get on tangy