Cutting out
Posted: Fri Jun 06, 2008 8:31 pm
Hi There,
Just replaced the head on my 2lte with a new 3l head, motor fired up first time and ran smoothly,
However, when decelerating or sitting at idle the motor cuts out,
When putting the new head on I took the time to block the egr valve with a blanking plate to the intake manifold end. Checked timing and all, looked good. Idling a bit low at 600rpm though
I am picking that the low idle is the problem, that or fuel or air supply. how can you adjust the idle?
Any help would be appreciated, thanks in advance
Just replaced the head on my 2lte with a new 3l head, motor fired up first time and ran smoothly,
However, when decelerating or sitting at idle the motor cuts out,
When putting the new head on I took the time to block the egr valve with a blanking plate to the intake manifold end. Checked timing and all, looked good. Idling a bit low at 600rpm though
I am picking that the low idle is the problem, that or fuel or air supply. how can you adjust the idle?
Any help would be appreciated, thanks in advance