Offroad-Express

well went to take my terrano for a warrant today and failed on the brakes when you hold your foot on the brake it gradually goes down or that was the machanics words. in other words the brakes dont work good enough. replaced the master cylinder then tryed to bleed the brakes (was pissing down with rain and have no shed to work in but water wont hurt you) it has disk brakes all round so started at left rear, right rear, left front then right front i thought there was another bleeding point along the chassi rail somewhere looked for it but couldnt find it. then after i bleed the brakes pressed on the brake pedle and it went in about 1/3 of the way which i thought was ok but when i turned the engine on then pushed the brake it went straight to the floor. im a little puzzled atm so if anyone could help me that would be great as im suposed to be going to the laurie sanson on sunday. thanks

martin

you could bleed it again leave it ,try again tomorrow give the air in the lines chance to settle, worked on the sons 40

hey thanks for that i did leave it all night to settle and blead fine in the morning and finaly got a wof thanks to the machanic letting me use his hoist and tools and showing me how to addjust the rear drums only cost me 20 bucks too:)

martin