Offroad-Express

Hi there I am currently swapping over body's I am putting a hard top body on my JTop chassis as the running gear in the hard top is shot.
The problem is there is no wiring in the hard top for the rear diff lock and would need to swap over the entire loom which ain't gonna happen.
Has any one wired up the air pump for the rear diff lock and how is it done.
Cheers

Yeah ive done it.

Pretty simple if i remember correctly. I followed the gregorys manual for everything.

Luckily it has a wiring diagram of the whole setup for the rear diff locker and pumps. I had to put the Diff ECU and pump in. If i remember correctly the switch goes into the diff ECU and then the power etc comes from that. Someone might correct me however.