Page 1 of 1
Split case PTO units
Posted: Mon Sep 07, 2009 6:14 pm
by turoa
I was wondering if anyone could measure how much a split case PTO unit sticks out in comparison to the tcase? i.e if you looked at the t-case from behind, how far out it sticks from the top of the flange where it bolts on.
Cheers
Re: Split case PTO units
Posted: Mon Sep 07, 2009 6:25 pm
by sig
cant be arsed to look but you are more than welcome to come and have a look
Re: Split case PTO units
Posted: Mon Sep 07, 2009 7:18 pm
by Beer_Cruiser
Ive got a pto unit in my shed you can have a look at
Re: Split case PTO units
Posted: Tue Sep 08, 2009 8:48 am
by mudzilla
250mm, from bottom of flange to the filler bolt on the PTO,, Top of the flamge is to hard to messure.. Fkn garage floor is cold too, Just in case you needed to know.
Re: Split case PTO units
Posted: Tue Sep 08, 2009 10:24 am
by Sadam_Husain
Got a spare one in the shed if you need to do a mock up or something
hmmm split transfercase..... this isnt that old green landy sitting over in the gorse is it
Re: Split case PTO units
Posted: Wed Sep 09, 2009 8:37 pm
by turoa
mudzilla wrote:250mm, from bottom of flange to the filler bolt on the PTO,, Top of the flamge is to hard to messure.. Fkn garage floor is cold too, Just in case you needed to know.
Sweet cheers for that. Cold floors are still nicer than working in dirt
all will be revealed in the fullness of time
Cheers for all the offers on borrowing em for a trial fit. I wanted to know if there was much point in making room for a future pto shaft, but it looks as if i will need to cut a portion of chassis away to fit
