Offroad-Express

Hi there i have a wait for it a 1968 landcruiser with the in line 6 petrol in it.
It is a bit sick and in need of some tlc i need rings, gasket kit, and berings for all of the bottom end can some one point me in the right direction as i can not find any no's on it thanks

its an "F" engine or some might call a 1F

ring BJ autos down south, he has heaps of stuff for the old girls

Yea it is an f eng and thanks will do toyota cant get the parts i need other than gaskets

wopass wrote:its an "F" engine or some might call a 1F

ring BJ autos down south, he has heaps of stuff for the old girls

you wonld'nt have a ph no for them do you

BJ Autos Four Wheel Drive Centre
305 Kaikorai Valley Road
Dunedin
New Zealand
Ph6434530685
fax6434530684


I think segedins used to list some cruiser rebuild parts?
www.segedins.co.nz

thanks for that just went onto web site and thay had the size that i need may be a good place the old girl may live again.
It is a prick that all the piston size is in inches

sounds like you are trying to keep it stock if not throw a 2f in ,dime a dozen and cheap as.or even go 3f they are a good motor as well

yea am tryin to keep it as stock as pos but ther are limits may get rid of the 3 spd box and put a 5 spd box in some day

here is a complete motor http://www.trademe.co.nz/Trade-Me-Motor ... 472972.htm

hay thanks that looks the same as the 1 i got in there now .
I got a mate at a eng shop to make me some new rings as i still could'nt find any