Offroad-Express

have just put a 1kzte with a r150 box into my 87 surf and it is stuk in 4 wheel drive is it electronicly controlled as i see it has sum electronics on it and if so what wires/ pins go whea?

What was the donor motor/box/tcase out of?, if it was a prado it will vacuum operated (there are 2 vacuum solenoids on the firewall usually)

motor supercustom van and box from toyota comercial wrecker its a r150 arnt they out of a v6 surf?

found in most LN, RN or KZN 130 Toyota Surfs

It should have the ADD thingy system??????????
http://www.4x4wire.com/toyota/tech/add/
http://www.off-road.com/trucks4x4/artic ... ?id=399612

thanx so you reken i shud jus get manual hubs to solve this problem

yes but your driveshaft will still spin, my mates is like that at the moment too, he has the little dog gear out of the transfer so only 2wd, we just gota wire in the module thing as his is electric

yea i compared with a surf today it is electric not vacum his has a button on the 4wd stick jus pres it with out moving the 4wd gear stick and it locks the front got my box from wrecker with out loom or the button on the gearstick does any one in wellington know how to wire this up

I run one of these boxes and they have an electric Worm drive motor on the back of the transfer case so is probably locked in.

Normally they are operated by an electric knob on the gear lever which winds them in and out. The motor quite often gives trouble and can get stuck in 4 wheel drive.

I have converted mine to air operated. Others fit a manual lever or else you need to get the wiring sorted to make it work properly.

They are a bloody good box

Cheers Richard

the lever sounds like the go but what was involved with the air operated one