Page 1 of 1
Oil pressure gauge fitting
Posted: Fri May 14, 2010 11:31 pm
by lincooln
Hi all, I want to fit an oil pressure gauge to my Zuk some time soon. I was just wondering how you do it? does the sender get put into the sump? I mean tap a hole in it and screw it in? or what?
Cheers
Lincoln
Sorry if its been covered before
Re: Oil pressure gauge fitting
Posted: Sat May 15, 2010 12:28 am
by Sadam_Husain
you want to run your existing gauge/warning light in tandem with the new gauge, 2 is always better than 1.
Pull your existing sender out and take it and the fittings for the new gauge down to ENZED or a simular shop and they'll find you a T joiner so you can connect them both in tandem together.
Re: Oil pressure gauge fitting
Posted: Sat May 15, 2010 6:18 pm
by Heath
Sadam_Husain wrote:you want to run your existing gauge/warning light in tandem with the new gauge, 2 is always better than 1.
Pull your existing sender out and take it and the fittings for the new gauge down to ENZED or a simular shop and they'll find you a T joiner so you can connect them both in tandem together.
What he said. ^^^^^
Re: Oil pressure gauge fitting
Posted: Sun May 16, 2010 8:58 pm
by lincooln
Sweet as, thanks guys