Offroad-Express

Have just replaced front diff,bent the old one got everything back together except brakes. Decided to replace brake caliper seals but I can't get the piston dust boot to stay in the groove in the housing?!! I've tried lots of times but it won't stay put, as soon as I push the piston up the boot follows. Any tricks to this?

Thanks for that coxsy,had another crack at it this morning & have nutted it out, push seal to bottom of piston, seat the seal into the housing & push piston through til seal sits in piston groove
How'd those 10" rims work out for you?

mudtroll wrote:Thanks for that coxsy,had another crack at it this morning & have nutted it out, push seal to bottom of piston, seat the seal into the housing & push piston through til seal sits in piston groove
How'd those 10" rims work out for you?

Hey man. You might already have this, but if not you will find it handy/

http://www.patrol4x4.com/forum/showthread.php?t=19193

we had a trial fit mid week, fit good he'll need to extend the flares a bit when he gets the swampers fitted