auto to manual hubs
Posted: Sun Jul 18, 2010 7:22 pm
is it as simple as just swapping them out for manual one...???
Offroad-Express
The opinions and viewpoints expressed by users of Offroad-Express Forums are wholly their own and not necessarily those of Offroad-Express.
https://www.offroadexpress.kiwi:443/Forums/
auto to manual hubs
https://www.offroadexpress.kiwi:443/Forums/viewtopic.php?t=21955
Page 1 of 1
Re: auto to manual hubs
Posted: Sun Jul 18, 2010 8:33 pm
Yes, just double check the spline count is correct.
Re: auto to manual hubs
Posted: Mon Jul 19, 2010 1:37 pm
sweet thanks just wasnt sure if they'd have there only different axles
Re: auto to manual hubs
Posted: Tue Jul 20, 2010 6:18 pm
Quite often the circlip goes in a different place with auto vs manual so make sure you get that right.
Factory auto normally has circlip in close to cv while manual often has circlip right near the end of the sub axle.
ie there is 2 grooves in the stub for the circlip.
Factory auto normally has circlip in close to cv while manual often has circlip right near the end of the sub axle.
ie there is 2 grooves in the stub for the circlip.
Re: auto to manual hubs
Posted: Tue Jul 20, 2010 8:59 pm
oh so true , learned the hard way 