Offroad-Express

This is an earlier model motor and not the ecotec. I am looking at supercharging it to get more power. I know that superchargers came on later models but would anyone know if it would be ok to supercharge an earlier model?

suzukisport wrote:This is an earlier model motor and not the ecotec. I am looking at supercharging it to get more power. I know that superchargers came on later models but would anyone know if it would be ok to supercharge an earlier model?

yup, SC14, make it a suck thru, std computer can go to about 8 psi before needing remapping, sc14 will give you about 3psi till you change the pulley

relocate coil packs, bolts to LH side of engine, need to machine one more groove in the supercharger pulley,
i put a rising rate reg on fuel rail just in case, means you can adjust fuel pressure if so desired.

cheers

pedro

Or if you want a bolt on kit: http://www.raptorsc.com.au/kits.php?id=1

Looking at this, but the guy is not to sure if it will fit a VP Commdore
http://www.trademe.co.nz/Browse/Listing ... =312098809

Anyone know if it would fit.
Cheers

Hmmmm could be a go!. Got any green paint?...should see whats in my driveway

I highly doubt that will work without a lot of modification. Looks like a factory supercharger which were in the VT - VX commodores and were ecotec.

suzookyman wrote:Hmmmm could be a go!. Got any green paint?...should see whats in my driveway

Hmm not sure we got any left anymore
You might have to come around for a beer and see