Page 1 of 1
Low Range Crawler gears
Posted: Mon Jan 17, 2011 6:59 pm
by Madaz
Is anyone on here running the marks 2.85 low range gears in a cruza split transfer case?
Looking for a bit of feed back on them.
Cheers
Re: Low Range Crawler gears
Posted: Mon Jan 17, 2011 7:02 pm
by Sadam_Husain
I'm pretty sure H20LOVA stuck some in his cruiser a couple of years ago?
Re: Low Range Crawler gears
Posted: Mon Jan 17, 2011 8:05 pm
by mudlva
mate put some in his 40 huge differance
im saving coin now so i can do the same
Re: Low Range Crawler gears
Posted: Mon Jan 17, 2011 8:28 pm
by Madaz
Im curious about what the actual speed difference was when they put the gears in.
I think that using the 2.85 gears with 4.1 diffs , would get the truck going the same speed as if i used the standard 2.4 transfer gears i have in there now, with 4.88 diffs
Re: Low Range Crawler gears
Posted: Mon Jan 17, 2011 11:15 pm
by pruggerdore
Wats the setup worth roughly??? I know the website but well we are disscussing it here
Re: Low Range Crawler gears
Posted: Tue Jan 18, 2011 6:46 am
by Madaz
They are around 2 grand if you get them from oz
Re: Low Range Crawler gears
Posted: Tue Jan 18, 2011 7:27 am
by kbushnz
Speed depends on what gear set you buy.
Some have 1:1 for high so normal driving unaffected.
Then different ratio for the low range.
Just depends on what you are trying to achieve.
Just a lower low range or change both high and low due tyre size change.
I hear they are good but can be a little nosier than standard.
Was going this way a few years ago due running 35's but scored some 4.88 diffs so now back to factory for my truck.
Calvin