Page 1 of 1
A15 Datsun Clutch wont engage.
Posted: Tue Jan 18, 2011 7:39 am
by Nz Zuki
Howsit everyone im running a A15 datsun 1600 motor and a 4 speed manual box in my suzuki sj410 and i used to be able to get the clutch to engage, recently replaced the clutch realease bearing or spiggot bearing as they say? and now i find that the bearing isnt pushing the pressure plate right in. like i cant get the clutch leaver to go all the way in.
Anyone know anythng that might help me out? its a bit frustrating! cheers!
Re: A15 Datsun Clutch wont engage.
Posted: Tue Jan 18, 2011 12:11 pm
by Nz Zuki
Anyone? please. Any help at all?
Re: A15 Datsun Clutch wont engage.
Posted: Tue Jan 18, 2011 3:42 pm
by Crash bandicoot
1: your clutch plate is around the wrong way
2: the clutch fork is not seated on its pivot point properly
3: the pressure plate prongs are not strong enough
4: the master cylinder on vehicle is not large enough to fully thrust slave from donor gearbox forward/back/sideways enough to disengage/ engage the clutch when you first did the transplant.
Now with a new parts you may need to make an adjustment rod to go between the slave and the clutch fork.
could be many things