Page 1 of 1
Burkes Metalworks - Panel work and fabrication
Posted: Tue Mar 22, 2011 9:44 pm
by wjw
If you need panel work done, extra seats. Any sort of metal fabrication Jason and the guys are great and won't cost you the earth:
http://www.burkesmetal.com/
Re: Burkes Metalworks - Panel work and fabrication
Posted: Thu Mar 24, 2011 5:35 pm
by Twodiffs
I can't speak highly enough of Jason. He has done my rear quarter chops over the years. I remember when he first started out as an apprentice he achieved the apprentice of the year under Shepherd & Kline in ChCh.
His father Gus was argueably ChCh's top panel beater when he was alive. Their work consists of stretch BMW limo's and heaps of american iconic cars.
Jason's brother Glenn is also a car trimmer and while he doesn't work out of Burkes Metalworks I would highly recommend him.
I'm a bit biased...Glenn has been a mate for decades. But if you want no BS work then give em a go.
Re: Burkes Metalworks - Panel work and fabrication
Posted: Tue Mar 19, 2013 8:21 pm
by netrom
Hi there,
I´m new to this forum.
My name is Morten and I´m from Norway (north europe).
I have been trying to get in touch with Burkes Metalworks for quite a long time, but they never seem to answer my emails - so I´m wondering if these guys are still in business? Can any of you point me to their attention?
With best regards
Morten
Re: Burkes Metalworks - Panel work and fabrication
Posted: Tue Mar 19, 2013 8:25 pm
by Twodiffs
Still in business, try phoning them on the number below, ask for Jason.
(03) 349 4413
Re: Burkes Metalworks - Panel work and fabrication
Posted: Tue Mar 19, 2013 10:03 pm
by IcedJohnno
Twodiffs wrote:Still in business, try phoning them on the number below, ask for Jason.
(03) 349 4413
Outside of NZ that number will be +64 3 349 4413
Re: Burkes Metalworks - Panel work and fabrication
Posted: Mon Apr 08, 2013 7:13 pm
by netrom
Thanks for the phone number, but my spoken english is not very good.
I have sent them several emails, but I don´t know if all of those (emails) are getting through to them or those (emails) might end up in thrash/spam filter box since I don´t get any answers?
I´m using
info@burkesmetal.com as email address.
May I ask if anyone of you guys please be kind and send them an email with a link to this forum thread?
Thanks in advance
Re: Burkes Metalworks - Panel work and fabrication
Posted: Tue Apr 09, 2013 5:55 pm
by Twodiffs
.
Re: Burkes Metalworks - Panel work and fabrication
Posted: Wed Apr 10, 2013 6:31 am
by wjw
Twodiffs wrote:Where abouts is your location???
He's in Norway
Re: Burkes Metalworks - Panel work and fabrication
Posted: Tue Mar 18, 2014 10:49 am
by netrom
Hi again,
Its me from Norway again.
Someone here made Burkes MetalWork get in contact with me - thank you.
I received an email from them - then I have tried replying for the last year, but never an answer back. Are you able to help me again?
Does anyone know if one of Burkes Metalwork´s guys are on this forum?
Thanks in advance
Morten