Rear quater chop's in akl area.

[JONO250]

Wanting to get my rear quarters on my swb saf chopped and plated, can anyone reccomend someone to do this?? prefereably in the auckland area

[coxsy]

bro its not hard to do a 4 or 5 '' grinder, safety gear, and watch out for the loom in the right rear quarter

[charo249]

I agree i did mine with a grinder pretty easy (would have been neater if 1/4 panel wasn't pretty beaten up by the time I got around to cutting it off) and even the fabrication of the new panels to replace the section I cut off wasn't to hard . Can now high lift jack from them to as I have a 5mm galv plate with some 3mm checkerplate alloy over top of everything.