Rear quater chop's in akl area.
Posted: Sat Apr 02, 2011 12:58 pm
Wanting to get my rear quarters on my swb saf chopped and plated, can anyone reccomend someone to do this?? prefereably in the auckland area
Offroad-Express
The opinions and viewpoints expressed by users of Offroad-Express Forums are wholly their own and not necessarily those of Offroad-Express.
https://www.offroadexpress.kiwi:443/Forums/
Rear quater chop's in akl area.
https://www.offroadexpress.kiwi:443/Forums/viewtopic.php?t=25196
Page 1 of 1
Re: Rear quater chop's in akl area.
Posted: Sat Apr 02, 2011 1:03 pm
bro its not hard to do a 4 or 5 '' grinder, safety gear, and watch out for the loom in the right rear quarter
Re: Rear quater chop's in akl area.
Posted: Sat Apr 02, 2011 3:45 pm
I agree i did mine with a grinder pretty easy (would have been neater if 1/4 panel wasn't pretty beaten up by the time I got around to cutting it off) and even the fabrication of the new panels to replace the section I cut off wasn't to hard . Can now high lift jack from them to as I have a 5mm galv plate with some 3mm checkerplate alloy over top of everything.