PTO winch for KZJ78 Toyota

[kbushnz]

Hi Yah All
Feeling inspired after the Winch Challenge.
Next project is a PTO winch setup like MudMike has done. (Could mid mount it instead)
So starting to collect bits.
Pretty much sorted the winch bit.
Need levers, drive shafts, PTO unit (prefer the reversible one) and a PTO gear for the transfer-case.
Anyone out there who has some bits they want to sell off drop me a PM.
I have been trolling on Trademe.....A few complete units but too far from home and a bit pricey.
Priced up new PTO gear... Not too bad.

Calvin

[kbushnz]

Well scored pto unit, drive shafts and levers.
Just need the PTO gear now.

Anyone have photo's of a centre mount winch?

Calvin

[Big]

i might have one floating around.. you'll have to wait till weekend for me to have a look..chers

[Sadam_Husain]

you'll need a short spacer as well as the PTO drive gear, you take the long spacer out and put the drive gear and a short spacer back onto the shaft



Dans mid mount thread http://www.offroadexpress.co.nz/Forums/ ... 24&start=0

[kbushnz]

i might have one floating around.. you'll have to wait till weekend for me to have a look..chers

Thanks for looking, I plan to machine down my old spacer by the thickness of the new pto gear.

you'll need a short spacer as well as the PTO drive gear,Dans mid mount thread http://www.offroadexpress.co.nz/Forums/ ... 24&start=0

Have had a good look at his, nice setup, would like to see how people thread the rope thru.
Must have a look at Steve's or Jeremy's

Calvin

[Big]

got the spacer here somewhere as well.. save ya coin..

[kbushnz]

got the spacer here somewhere as well.. save ya coin..

Sweet

Calvin