Page 1 of 1
snorkel on a escudo
Posted: Sat Oct 01, 2011 1:37 pm
by 89surf
just putting a home made job snorkel on my escudo can you get a pipe from the intake of the airbox that goes into a round pipe cause the factory pipe that comes out is like a half circle and a flat bit on bottom or is there any other ways around this
cheers
Re: snorkel on a escudo
Posted: Sat Oct 01, 2011 9:12 pm
by churchill
Is that the bit in the guard that's the funny shape?
Re: snorkel on a escudo
Posted: Sun Oct 02, 2011 7:09 am
by 89surf
yea it is
Re: snorkel on a escudo
Posted: Sun Oct 02, 2011 12:51 pm
by churchill
With my snorkel I had to remove that part and plumb the snorkel straight into the air box, that has a round fitting. My snorkel's made by Airflow but I think is a commonly done with most snorkel setups.
Re: snorkel on a escudo
Posted: Sun Oct 02, 2011 2:03 pm
by 89surf
yea airbox inlet isnt round eather pain in the arse might just get a bit of pvc stick that in there and silicone around it
Re: snorkel on a escudo
Posted: Mon Oct 03, 2011 4:59 pm
by churchill
Ok, that sucks.
Re: snorkel on a escudo
Posted: Mon Oct 03, 2011 5:10 pm
by 89surf
yep pain in the arse
Re: snorkel on a escudo
Posted: Mon Oct 03, 2011 6:03 pm
by kernels
Would it be worth getting some pvc that is roughly the right size, heat it up with a heatgun and bend to shape ?