WTB: 16 x 8 wheels - Landcruiser (80) stud pattern

[Danjr]

I'm after a set (4 or 5) steel wheels in 16 x 8 for an 80 series. Not too worried about condition. Offset of around -20 would be good.

Cheers

Dan

[crazyclark31]

how much you looking at spending bud? Pas got a set of alloys with half worn wranglers sitting round that he might be willing to part with.
Also were are you based?

Cheers
Mike

[Danjr]

how much you looking at spending bud? Pas got a set of alloys with half worn wranglers sitting round that he might be willing to part with.
Also were are you based?

Cheers
Mike

Cheaper the better but I already have a set of tyres sussed. In rotorua so might be a bit far.

Cheers

[skid]

here ya go dude

this should happily scare the living crap out of ya

unless you just won lotto

http://www.trademe.co.nz/motors/car-par ... 259550.htm

[88 4runner]

ive got a set of 4 bfgoodrich Deerfield rims here in whakatane. -13 offset not to bad condition.

[Danjr]

here ya go dude

this should happily scare the living crap out of ya

unless you just won lotto

http://www.trademe.co.nz/motors/car-par ... 259550.htm

Yeah what gives with that price? I see there were some 'xtreme use' ones on their for $500 so not sure what is special about these?

Besides, they're just going to get bent and twisted anyway so don't need anything that purty.

[Danjr]

ive got a set of 4 bfgoodrich Deerfield rims here in whakatane. -13 offset not to bad condition.

They might look alright on it. Will send you a PM.

Cheers

Dan

[Danjr]

Decided to try and find some steel ones if anyone has anything. Looking to pay around $200.

[skid]

good luck dude

I been looking to buy 16x8 steels for ages now and no joy, so am thinking of just sucking it up and buying the new ones (the cheaper ones)

we got some factory 16x8 cruiser alloys at work for sale, 5 of them 0 offset