Page 1 of 1
Can anyone recommend a good alloy tig welder? (Canterbury)
Posted: Thu Dec 01, 2011 6:07 pm
by Mud Hog
As title ses can anyone recommend an alloy tig welder in christchurch? need a small bit of intercooler outlet welded back on as I Trimed it a bit much.
Cheers
Re: Can anyone recommend a good alloy tig welder? (Canterbur
Posted: Thu Dec 01, 2011 6:36 pm
by Petemcc
Priest sheetmetal and plate. Talk to Sam. They are at 10 barbour street 366-9818
Re: Can anyone recommend a good alloy tig welder? (Canterbur
Posted: Thu Dec 01, 2011 7:01 pm
by pressy
what area of chch are you close too? home or/and work?
Re: Can anyone recommend a good alloy tig welder? (Canterbur
Posted: Thu Dec 01, 2011 8:14 pm
by mud_slinger
go and see mike at A1 radiators he is good he makes intercoolers for a living. tell him hamish sent ya
Re: Can anyone recommend a good alloy tig welder? (Canterbur
Posted: Thu Dec 01, 2011 9:01 pm
by Mud Hog
pressy wrote:what area of chch are you close too? home or/and work?
Live Hoon Hay, work rolleston.
Cheers for the replies
Re: Can anyone recommend a good alloy tig welder? (Canterbur
Posted: Thu Dec 01, 2011 9:37 pm
by rokhound
I have a guy in Chattertons rd who can sort you. Look up Jet Stream services in the ph book and ask for Miles. Tell him Westie sent ya
Re: Can anyone recommend a good alloy tig welder? (Canterbur
Posted: Fri Dec 02, 2011 5:39 am
by pressy
royce clive engineering,
www.roycecliveengineering.co.nz/ Unit 4/7 Nga Mahi Rd, Sockburn
off Blenheim road, turn at blacks fastners on the left heading towards hornby
Re: Can anyone recommend a good alloy tig welder? (Canterbur
Posted: Fri Dec 02, 2011 6:38 am
by jonossiksilvia
Austons alloy welding has done work for me. Cheapest when I was looking and bloodly tidy. Id never think twice going back to him. He done my stuff for 75 instead of others charging at least 170.. He on gasson st next to chase exhausts and opersite bumper shop.
Re: Can anyone recommend a good alloy tig welder? (Canterbur
Posted: Sat Dec 03, 2011 7:41 am
by andrew007
go to austins m8,really good welder ,cheap, does alot of tricky stuff.
Re: Can anyone recommend a good alloy tig welder? (Canterbur
Posted: Sat Dec 03, 2011 10:57 am
by IcedJohnno
I highly recommend P.A.D. Racing, 37a Hands Rd off Birmingham drive.
Garry is an ex Air NZ aircraft engineer who has welded all sorts of tricky stuff for me over the last 15 years. his welding experience ranges from British touring car nissan cyl. head fabrication through to Trials buggy chassis, to Formula 5000 monocoques.
He is also one of the best dyno tuners in town as well. Champion success in all forms of competitive NZ motorsport.
Contact Garry on 338 6288