Page 1 of 1
hulux power steering box into sj413
Posted: Wed Aug 02, 2006 8:54 pm
by weekenda
hi does any one know if this can be done?
Posted: Thu Aug 03, 2006 5:34 pm
by Rotazuk
Not so much a hilux but toyota creseda bolts in rather nicely with an adaptor plate from Ben onto the chassis . Does not nee any steering shaft mods and uses a vitara pitman arm to complete the linkage , very certifiable I would say .
My setup , the bits in red were trail fits and are still being used today but the plate of ben is very nice .
http://www.geocities.com/rota_zuk/Suzuk ... rsteer.htm
Posted: Thu Aug 03, 2006 8:02 pm
by mroffroader
nice page rota...good tech too
Posted: Thu Aug 03, 2006 8:13 pm
by turoa
so do the cressida boxes swing fowards? and are they the old type that people get the 2.8's out of?
Posted: Thu Aug 03, 2006 8:18 pm
by Rotazuk
Yep they swing forward as they operate on the back of the hubs .
To fit a zuk you take the pitman arm off ( have to change it anyway ) and point it backwards . Makes it the same then .
If you are looking for a box to fit having a forward facing arm that works on the front of the hubs ( like zuk or toyota , get a daihatsu rocyk/rugger/blizard steering box .
Yep out of the early 80's 2.8's and the corona mark 2's . Also celeca's of the 80 to 82 era ( what ever model that was ) .