Page 1 of 1
Oh dear - major cock up - flywheel machining wellington
Posted: Mon Feb 27, 2012 11:37 am
by mike
HI All,
Anyone have a lathe that can grip 380mm? I may have sheared the key off and scored the bajeesus out of the taper on the flywheel
twice
I need to take out 0.1mm or 0.2mm out of the taper on the flywheel to clean it up and try and make the keyway nice again. Anyone have access to an old(or new) lathe that can handle this
worth couple of boxes of the good stuff at least
we all love to help an idiot out
Re: Oh dear - major cock up - flywheel machining wellington
Posted: Mon Feb 27, 2012 12:32 pm
by mercutio
i know where there is a decent size old lathe but it is in tokoroa
Re: Oh dear - major cock up - flywheel machining wellington
Posted: Mon Feb 27, 2012 12:39 pm
by SMOKEY
Hi Mike, I could help out if you are in CHCH , but Wellington could be a bit tricky unless the ORE courier system could kick in ????. . You have done a few taper fits
, to know if there not spot on ,
SHIT HAPPENS,
FITZY.
Re: Oh dear - major cock up - flywheel machining wellington
Posted: Mon Feb 27, 2012 1:34 pm
by mike
SMOKEY wrote:Hi Mike, I could help out if you are in CHCH , but Wellington could be a bit tricky unless the ORE courier system could kick in ????. . You have done a few taper fits
, to know if there not spot on ,
SHIT HAPPENS,
FITZY.
could be an option
anyone heading south?
Re: Oh dear - major cock up - flywheel machining wellington
Posted: Mon Feb 27, 2012 2:47 pm
by niblik
SMOKEY wrote:Hi Mike, I could help out if you are in CHCH , but Wellington could be a bit tricky unless the ORE courier system could kick in ????. . You have done a few taper fits
, to know if there not spot on ,
SHIT HAPPENS,
FITZY.
ditto to this...
Re: Oh dear - major cock up - flywheel machining wellington
Posted: Mon Feb 27, 2012 5:13 pm
by Jafa
Drop me a line Mike, [in best John Wayne voice] "I'll fix yur wagin"
0212527201
Re: Oh dear - major cock up - flywheel machining wellington
Posted: Mon Feb 27, 2012 6:38 pm
by mike
look who has popped out of the woodwork - ole jafa
hope you realise, it aint gonna need 82" of travel
