Page 1 of 1
map sensor manifold fitting
Posted: Sat Mar 24, 2012 12:03 pm
by dean zuk
Whereabouts would i be able to source one of these? as mine was broken as we were removing the engine from the donor truck.
For a G16a tbi
Heres a pic of the part:
Also what the part called?
Cheers
Dean
Re: map sensor manifold fitting
Posted: Sat Mar 24, 2012 4:42 pm
by muddyhilux
id be suggesting wrecker as it'll need to be a sensor matched to the vehicles computer.pretty sure repco and the likes don't to map sensor replacements.maybe wrong though
Re: map sensor manifold fitting
Posted: Sat Mar 24, 2012 5:55 pm
by ONOescudo
I too had the same sender broken doing my motor conversion. Mud Bits sent 2 as there seems to be different hose sizes, the one I need has a 4mm pipe and the one I wont be using has a 6mm pipe, which you are welcome to have.
It’s a Manifold Absolute Pressure (MAP) sensor so sates the Haynes Manual.
Located behind the TBI threaded into the manifold.
http://www.mudbits.co.nz Cheers MIKE.
Re: map sensor manifold fitting
Posted: Sat Mar 24, 2012 6:13 pm
by ONOescudo
Hay hers a thought. Could you take a picture of the bracket that holds up the right side of the air inlet pipe that’s across the top of the motor. I haven’t got one. Might make it a bit easier to fab one up or get the correct unit as I have been sent the wrong bracket.
Cheers MIKE.
Re: map sensor manifold fitting
Posted: Mon Mar 26, 2012 9:17 pm
by dean zuk
Cheers for that gave them an email.
And yes i can take a photo of that bit for you when i dig it out
