Offroad-Express

Posted: **Thu Apr 12, 2012 6:22 pm**

bit of a long shot here but,

iv got a 60 series with a spring over and after market steering arms (snake racing ones). now my left hand tie rod end needs replacing and the standard one is wrong.
the standard one has an eye on it.

i need on like this.

any idea what i can do? been to repco and there crap. anyone know what else may have one i can use?

Posted: **Thu Apr 12, 2012 6:27 pm**

mine looks like this.

Posted: **Thu Apr 12, 2012 6:50 pm**

When I did my custom set up with 60series and lux stuff with custom rods I went to BNT and asked real nice to see there book of tie rod ends. Went to the toyota section and had a hunt. There are all sorts there and bound to be one to suit. Just check the tread size, toyota stuff is a queer 21mm thread. Most aftermarket is 20 or 22mm

Posted: **Thu Apr 12, 2012 10:39 pm**

80 series would be my guess

Posted: **Fri Apr 13, 2012 5:56 am**

tomsoffroad wrote:80 series would be my guess

That's normally what snake an trail gear use for their high steer kits :wink:

Posted: **Fri Apr 13, 2012 10:18 am**

Hi,
Series 80 are M23 x 1.5mm. Yes very oddball size.

Do you need a LH or RH thread one.

Cheers
Tim

Offroad-Express

60 series, spring over, what tie rod end??

60 series, spring over, what tie rod end??

Re: 60 series, spring over, what tie rod end??

Re: 60 series, spring over, what tie rod end??

Re: 60 series, spring over, what tie rod end??

Re: 60 series, spring over, what tie rod end??

Re: 60 series, spring over, what tie rod end??