Offroad-Express

Hi I am going to do a front mount and think an intercooler 450x150x65 will fit best down low were I want it to go,will that size be to small to big or ok,thanks.

Have a quick search as this as been covered as a lot of guys have already done it

Thanks Dan have searched but did'nt much on how to size them.

this shou;d bolt straight on

http://www.trademe.co.nz/Browse/Listing ... =477017173

Thanks Jerry but don't want top mount and they are not very cheap.

Just go with a 300x280x75 I've got one on my 1kzt it's bit of an over kill rated for enough flow to 500 hp but works well

klompy wrote:Hi I am going to do a front mount and think an intercooler 450x150x65 will fit best down low were I want it to go,will that size be to small to big or ok,thanks.

it'll be fine, i ran a 450x180x65 on my 4.2 cruiser for over 2 years.

Thanks strx7.

if ya havent sorted it out yet and need some info. i run a custon intercooler setup using a nissan avenir sr20det intercooler, seems to work quite well, ive gone top mount on mine, there is a little boost lag but dont notice it in 4x4. only got it for 50 aswell so im happy with it.

Could you chuck a couple of pics up? I have a couple of r32 skyline ones sitting here I am going to try and adapt into a top mount.

yea man, il try and get some good pics tomorrow for ya.my setup is abit hory, wont win any awards but does the job well.

this is my setup.