Offroad-Express

As above would front leaf springs from a bj61 fit onto a bj41 with out troubles?

Yeah mate perfect fit should only take an hour or so, have a search around its been done heaps , gives fully sick flex too

Will need to watch what year BJ40 you are putting the springs into.

Older ones run 15mm pins vs newer ones run 18mm pins.

Can be sorted just something to keep in mind.

MNC wrote:Will need to watch what year BJ40 you are putting the springs into.

Older ones run 15mm pins vs newer ones run 18mm pins.

Can be sorted just something to keep in mind.

Its a 1980 Bj41

http://www.trademe.co.nz/motors/car-par ... 297575.htm

Would these fit??

Scobby12 wrote:http://www.trademe.co.nz/motors/car-parts-accessories/toyota/suspension/auction-512297575.htm

Would these fit??

dunno about the rear springs but 70 series front springs are about 15mm longer than 40 series springs so they bolt straight in but you have to watch the centre pin coz it moves the axle further forward, cant remember how much but I think its around 70mm or something like that?

Sadam_Husain wrote:

Scobby12 wrote:http://www.trademe.co.nz/motors/car-parts-accessories/toyota/suspension/auction-512297575.htm

Would these fit??

dunno about the rear springs but 70 series front springs are about 15mm longer than 40 series springs so they bolt straight in but you have to watch the centre pin coz it moves the axle further forward, cant remember how much but I think its around 70mm or something like that?

Ok thanks mate, would anyone know where i could get a second hand set of front springs for a 40? not looking to lift just want to replace my flat ones