Page 1 of 1
sj413 on a lean??
Posted: Mon Sep 04, 2006 6:19 pm
by mushroom11
just got a set of 50mm lift maxi trak leaf springs for my zuk now all springs are all ok besides the front drivers side is on a mean lean down now i followed intructions with placeing driver sring and passenger spring in correct place and stool on a lean i put in air shocks in hopeing that would fix it but no its stool on bad lean i have removed my sway bar any of you guys had experience with this before???
Posted: Mon Sep 04, 2006 6:25 pm
by DaveM
Would think there is a logical explanation, but I don't know what it is
Who'd you get them from? Have you asked them for advice?
Posted: Mon Sep 04, 2006 7:05 pm
by Insky
maxi track is i good brand a lot of guys run there trucks on them (steve) supralux on this forum sells them and has experience with them im sure he gud give u advice i would say either the part is faulghty or it has been inslaled incorectly
where did u buy them from ?
my 2c
Posted: Mon Sep 04, 2006 7:20 pm
by mushroom11
that guy steve dunford with the lifted isuzu mu yea would of fort there was something simple but looked at it over and over again but cant seem to see anything???could it b that i removed the sway bar?
Posted: Mon Sep 04, 2006 8:05 pm
by DaveM
Contact Steve first, he may be able to tell you straight away
Posted: Mon Sep 04, 2006 8:36 pm
by mushroom11
hes a hard guy to get a hold of?he must not use the net a lot?