Offroad-Express

As title

Needed a steel shim that sits between the front brake calliper hanger and the front brake pads. Left hand side lower?

Im in Christchurch

Num is 027 209 1025

Wouldn't put number up normally but desperate for one as need 4wd for course tomorrow!!!!!!

Just run without it,a lot of people just throw them away.

klompy wrote:Just run without it,a lot of people just throw them away.

And it will be fine?

The pads are really loose with out them

Yep use the brakes once and they will sit right.

sweet. Will try it soon

Pretty sure there only there to stop noise.

Yea left the the left hand side ones out now they squeal and they are brand new pads/disk

Still needing some please

Are they single or double pot calipers? I might have some lying around but shipping will more than it may be worth. Have you tried around local to you?

Cheers

sibainmud wrote:Are they single or double pot calipers? I might have some lying around but shipping will more than it may be worth. Have you tried around local to you?

Cheers

Twin pot, You mean try wreckers?

I thought I would try on here first but looking like a dead end

Sorted!!

Thanks sibainmud!

You're most welcome. Hope they work.

Cheers,

Ussually vehicles are fine with out the shims, just chuck brake grease on the backing of the pad and it should be good as gold

Read the post again.......the spring clips are what he was after not the backing shims. The clips that go at the top and bottom of the pad and cushion the up and down movement....at least that is what I sent him. Seams to be sorted now

Cheers,

sibainmud wrote:Read the post again.......the spring clips are what he was after not the backing shims. The clips that go at the top and bottom of the pad and cushion the up and down movement....at least that is what I sent him. Seams to be sorted now

Cheers,

Yep what you sent was what I needed, The pads were really loose with out them and would squeal when putting my foot on the brake

Thats not how I read his first post