Offroad-Express

ive been looking at seats to replace factory ones, they are comfy to sit in, but dont help much when your off road and u get thrown around quite a bit.

WRX seats are pretty cheap on trademe, I was just wondering if anyone had any pics of the seats and rails fitted into a suzi

I don't know anyone who has done this as of yet.

But i'm sure it would't take much to alter or get a pro to alter the existing rail's to mount the REX seats.

I have found custom rail's for the vitara designed for aftermarket bucket seat's on the net,
ill put a link up when i get home from hunting down a rear axle seal.

I have WRX STI seats in my Escudo,its easy to do if ya can weld but I dont have any photos of the adaptor I made. The Zuk rails have one mounted on the floor and the other on the tunnel so there is a different height you have to work out so the seat sits level. I got my seats to sit 30mm lower than standard,have also fitted Recro and autosport seats to Zuks.
Cheers Woody.

Here's some aftermarket seat mounts:
http://www.twinstickoffroad.com/products/Vitara-seat-mount-kit.html

Ive fitted bucket seats into my vitara,And what I did was get anther set of seats and chop the bottom off it so I had the right height.A couple braces and they were sweet.

zukmeista wrote:Here's some aftermarket seat mounts:
http://www.twinstickoffroad.com/products/Vitara-seat-mount-kit.html

Cheers zukmeista,
This is the link i was thinking of earlier.....

Thanks all for the replys, exactly what i was lookn for