Coil on plug tacho

[zuky]

I have recently done an engine swap to a coil on plug engine and was wondering how to hook up the tacho now there is no coil.

I replaced my 1300 with a 1600 muilti point in the zuk. Any suggestions/help would be great.

Is it as simple as finding an output on the computer for the tacho? Or do I need some gadget (interface) to get my once carb tacho to understand the new output? Or can I take a feed off one of the coils?

I don't know so hopefully someone has been through this and can help

It's two coils with redundant spark, not sure how that effects it either. All I know is it goes great and uses bugger all gas now