WTB: KZN130 3 or 4" panhard rod drop bracket!

[bronx89]

As per title. New or 2nd hand (excellent condition). In Aucks can pay shipping as it'll be cheap. Ta.

[mike]

dam, ill jump on the bandwagon for this as well, guess I need one now that I'm getting the surf done all "proper"

so make that x2, but bronx was first inline if there is only one floating around.

[bronx89]

Haha sweet as.

How much do these usually go for? I've just found a place overseas that does them for about $120-130NZD incl. shipping. Would prefer cheap 2nd hand though funds are a bit tight at the mo!

[jonossiksilvia]

Get hold of Tomsoffroad. He made mine for me 3'

[bronx89]

For how much? Yea I'll need a 3 or 4" one as I've got a 3" susp lift. I think he quoted me about $230...

[jonossiksilvia]

pm him. i cant remember what i paid but i know it was cheap (perhaps it was cos i supplied him a drawing that he may or may not still use)

[bronx89]

Yea I just looked through mymold pms and I had messaged him.was quoted $230. Will stick to looking for a second hand one or might try out this offshore crowd. Spending too much $$ on this damn truck so need to start saving some coin on what I'm buying for it

[DEATH_INC]

Where in aucks are ya?
Can prolly make one up, but I'll need the vehicle, or some very accurate measurements....

[tweake]

au surf site has a diagram with measurements.
if i remember right 3" is the smallest you can go.

[bronx89]

Where in aucks are ya?
Can prolly make one up, but I'll need the vehicle, or some very accurate measurements....

Will PM you now, I have diagrams with all measurements or can probably bring truck to you.

[DEATH_INC]

if i remember right 3" is the smallest you can go.

That makes sense, when I made My terrano one it was the same...you need it to allow the panhard to fit into the wider part of the bracket.

[bronx89]

Yea that's fine, did a rough measurement on mine yesterday and my RHS mounting point needs to come down about 100-120mm. So might even get a 4" one.

[bronx89]

Found them from the states pre-made 4" suitable for 2-3" lift $100 incl shipping. If anyone needs one let me know.

[tweake]

Found them from the states pre-made 4" suitable for 2-3" lift $100 incl shipping. If anyone needs one let me know.

pm sent

[bob_or_jim]

http://toyotasurf.asn.au/techsite/downloads/PanhardRodDropBracket.pdf

This is off the Surf ASN website.

Enjoy

[bronx89]

Yup already had that cheers anyway.