Offroad-Express

Yesterday i decided to remove my side panels of my lux and inspect a crack that I had noticed in the engine bay. Much to my sorrow i found 3 good rust points two of them my screw driver went straight through into the cab



My question is does anyone know someone or a place where i can get these rust holes ground out and welded along with the cracks in the engine bay and not get ripped off like when i paid $500 to fix a small hole bellow the pillar and they just bogged (which is where it has rusted out now)

Shop around, if you do the prep you might luck in and get someone willing to do it for beers or a few bucks.

Did you want good, or cheap?

Sh0tgun wrote:i paid $500 to fix a small hole bellow the pillar and they just bogged (which is where it has rusted out now)

have you checked for a leak problem if the same areas continuing to rust out?

Doesn't have to look good cause it's hidden behind the wheel arch haha.

The A pillar did have some rust and a leak awhile back, been fixed and its above these patches so i believe that is to blame.

Would anyone be willing to lend a hand for beers or bucks or a combo of the two?