Engine swapping in a UBS55 Bighorn
Posted: Mon Oct 09, 2006 8:19 pm
Gidday,
I recently swapped a diesel Camry for a 1990 LWB UBS55 Bighorn Irmscher S. It has an exceptionally straight tidy body and interior. I have a 1989 SWB Bighorn Irmscher S which has a great 2.8 in it but a shabby body - right hand chasis rail is 15mm shorter due to owning an Audi in the middle of nowhere at about 1am.
I want to put the engine out of my SWB into the LWB, and just want to know if ano=yone knows of any pitfalls in doing this swap. Is there anything anyone recommends I do or dont do?
Is it a straight forward swap? It looks a little more complex than the 2WD conversions I have been involved in in the past.
Any info anyone can give me would be greatly appreciated!
Thanks in advance
Blair
I recently swapped a diesel Camry for a 1990 LWB UBS55 Bighorn Irmscher S. It has an exceptionally straight tidy body and interior. I have a 1989 SWB Bighorn Irmscher S which has a great 2.8 in it but a shabby body - right hand chasis rail is 15mm shorter due to owning an Audi in the middle of nowhere at about 1am.
I want to put the engine out of my SWB into the LWB, and just want to know if ano=yone knows of any pitfalls in doing this swap. Is there anything anyone recommends I do or dont do?
Is it a straight forward swap? It looks a little more complex than the 2WD conversions I have been involved in in the past.
Any info anyone can give me would be greatly appreciated!
Thanks in advance
Blair