Page 1 of 1

Toyota RZN169 & 3RZ Parts wanted

Posted: Thu Jul 04, 2013 7:49 pm
by Hilux Dan
Does anyone know of a RZN169 model Hilux being wrecked ?? Im after the outer CV and the dust cover seal that the CV goes tghrough into the hub.

Toyota NZ dont have the seal, its ex Japan. Toyota NZ only sell the complete drive shaft with the inner and outer CV which I dont need, so I bought an after market CV from Partmaster. Managed to track down a seal but it doesnt fit on my after market CV. What to do ?? Is the seal wrong ?? or is the CV wrong ?? Toyota have been unhelpful fu@kwits to say the least....

Also 3RZ parts, powersteer pump etc ??

Cheers

Re: Toyota RZN169 & 3RZ Parts wanted

Posted: Thu Jul 04, 2013 8:59 pm
by BlakeNZ
There is a 3RZ regius van being wrecked at Ohakune.
http://www.trademe.co.nz/motors/wrecked ... 815737.htm

Re: Toyota RZN169 & 3RZ Parts wanted

Posted: Thu Jul 04, 2013 11:08 pm
by Mehrts
The CVs are definitely the same between all Hilux models between 1998-2005.

I'd even go so far to say that all 4WD Toyota vehicles with IFS have the same gear from the CVs and 7.5" front diffs (differing ratios obviously) to the hubs.

So you can broaden your search with the diesel options too without too much trouble.

Re: Toyota RZN169 & 3RZ Parts wanted

Posted: Fri Jul 05, 2013 12:10 pm
by Drurban
I would try Parts Connection these guys are pretty good.

Re: Toyota RZN169 & 3RZ Parts wanted

Posted: Fri Jul 05, 2013 5:33 pm
by Hilux Dan
So I have determined the CV is correct, so its the seal thats wrong. Have bitten the bullet and ordered Ex-Japan $95......what a rip off !!! but I have no choice.....Im sick of driving all over Akl looking for this one......cheers for your input......

Re: Toyota RZN169 & 3RZ Parts wanted

Posted: Fri Jul 05, 2013 5:35 pm
by Hilux Dan
Im actually a little surpised peps havent said "Just SAS it !!" ......... if only I had the $$

Out of curisoity, what parts are needed to do a SAS ??