Page 1 of 1
Anyone want some coil spacers??
Posted: Tue Oct 17, 2006 9:32 pm
by icekayak
Anyone interested in some coil spacers for a vitara?
Just got some material but only came in enough to do a couple of trucks, so going to use mine as a gunie pig for some 25mm ones probably, but if anyone wants some after that should be able to whack up a couple more with the stuff i've got for a reasonable price
Its the proper stuff (UHWMPE in Black). Will only cost a couple of bucks to ship round the country.
I do not know the legalities of using them and if they need to be certed or not. I suspect they need to be however...
Posted: Tue Oct 17, 2006 10:21 pm
by spanky
mate ,they sound good let us know how much you would want for them i could be keen on some for my gem , cheers
vaughan
Posted: Wed Oct 18, 2006 5:26 am
by mroffroader
yea i may be keen how much? are they for the front and back? cheers man
Posted: Wed Oct 18, 2006 9:56 am
by Bubba
Me too!!!
James, bugga off and go do some homework or go surf for porn like most normal 15year olds!!
Posted: Wed Oct 18, 2006 10:53 am
by icekayak
Yeh can do front and back (pretty sure anyway)
But will confirm once got them onto mine...
Price depends on size and how long it takes me to cut them all out. but would guestimate about $80 a set initially for 30mm ones.... possibly slightly less for a guniee pig out there...
Remember that cos of the front geometery it will be 1.5 times what ever you put in, and the back is 1 times.
ie if you put 30mm spacers all round you will get 45mm lift at front and 30mm at rear.
Will be similar to these (note u only need 4 to do a car) but in black (cos looks more stock)
Posted: Wed Oct 18, 2006 2:17 pm
by turoa
Bubba wrote:Me too!!!
James, bugga off and go do some homework or go surf for porn like most normal 15year olds!!
Hes only 14
Posted: Wed Oct 18, 2006 7:04 pm
by mroffroader
15 next tuesday :p
Posted: Wed Dec 13, 2006 10:59 am
by jeremyisme
icekayak, do you still have some of that stuff lying around? I would be keen for a couple of 20mm ones, for the front of my Vitara.
Otherwise, can you tell me where you got that stuff from?
Posted: Wed Dec 13, 2006 11:15 am
by icekayak
Got it from the local bearing shop in a 4" Diameter roll (I think)
IT IS A PAIN TO CUT THOUGH....
Are you handy with a drill?
I'll send you a pm...