Page 1 of 1
Angle Grinding chch
Posted: Sat Nov 30, 2013 9:38 am
by a80crewza
Can anyone help me out with a bit of angle grinding please? Need two small pieces of steel cut of my truck, trying to fit my bullbar.. I'm in chch. Thanks. Tom, 0276807464
Re: Angle Grinding chch
Posted: Sat Nov 30, 2013 10:39 am
by SamLogan
where are you located? or could you come to me?
Sam
Re: Angle Grinding chch
Posted: Sat Nov 30, 2013 10:43 am
by muddy
Re: Angle Grinding chch
Posted: Sat Nov 30, 2013 1:07 pm
by a80crewza
All sorted thanks fellas
Re: Angle Grinding chch
Posted: Sat Nov 30, 2013 2:28 pm
by Heath
muddy wrote:http://www.bunnings.co.nz/xu1-corded-angle-grinder-100mm-500w_p06290200
Gotta love "lil Mr Angry"...
Re: Angle Grinding chch
Posted: Sat Nov 30, 2013 3:30 pm
by nzlux
Heath wrote:muddy wrote:http://www.bunnings.co.nz/xu1-corded-angle-grinder-100mm-500w_p06290200
Gotta love "lil Mr Angry"...
I went through 5 of those when fitting an alloy bar around the winch on my pajero… luckily I was living in town at the time so 10 minutes after I cooked one I had a new one to destroy