Page 1 of 1
Anyone Willing to make me a dump pipe?
Posted: Fri Dec 20, 2013 3:50 pm
by travis2ninja
Hi,
Is anyone willing to make me a 2.5" dump pipe for my TD27T Terrano.
Preferably in Australia? With the 3 bolt flange?
Re: Anyone Willing to make me a dump pipe?
Posted: Fri Dec 20, 2013 4:21 pm
by fish
Sorry cant help you. What is the benefits of this pipe?
Re: Anyone Willing to make me a dump pipe?
Posted: Fri Dec 20, 2013 6:22 pm
by hamboy
Do the whole dump pipe, not just the bit on the bottom.
Something like this
Factory one's are tiny and restricted as f*%k. Loose the mufflers while you're at it, makes a big difference to how they go
Re: Anyone Willing to make me a dump pipe?
Posted: Sat Dec 28, 2013 6:22 pm
by nickmcdonald
Ahhh Ive been looking into getting one of these made too. Being off the back of the turbo, the exhaust gas is gonna be warm to say the least. What sort of wall thickness pipe would need to be used, assuming i get it made from fairly ordinary steel. Would 3mm wall thickness suffice? And what diameter pipe? Just the biggest that still fits onto a flange?
Re: Anyone Willing to make me a dump pipe?
Posted: Sun Dec 29, 2013 1:15 pm
by hamboy
nickmcdonald wrote:Ahhh Ive been looking into getting one of these made too. Being off the back of the turbo, the exhaust gas is gonna be warm to say the least. What sort of wall thickness pipe would need to be used, assuming i get it made from fairly ordinary steel. Would 3mm wall thickness suffice? And what diameter pipe? Just the biggest that still fits onto a flange?
I've just used 2 1/2 inch exhaust tubing and made my own flange by tracing the gasket onto a piece of 8mm flat bar (I think) and had the local muffler shop bend it all up. Also the above pic isn't mine, just one I found lol