Offroad-Express

Posted: **Thu Apr 02, 2015 6:35 am**

Old disks too thin.
Anyways,I pulled both hub covers and shafts off to change over to new rotors.
Will this be an issue aligning shafts back into the diff?
Or should I have done 1 side at a time?
Too late now for me.
Replacing bearings and cups whilst all the fruit is out.
Cheerz

Posted: **Thu Apr 02, 2015 12:44 pm**

Long shaft went in OK,so all should be good.

Posted: **Wed Apr 15, 2015 12:35 am**

I have had both out same time and they went in just fine.

Posted: **Wed Apr 15, 2015 5:34 pm**

Disco Gofer wrote:I have had both out same time and they went in just fine.

+1

Offroad-Express

Rear rotor disks D1

Rear rotor disks D1

Re: Rear rotor disks D1

Re: Rear rotor disks D1

Re: Rear rotor disks D1