Offroad-Express

Been thinking about doing a U Bolt flip on the 70
Anyone done this? Did you use a kit or fab your self? If kit where did you get it,how much?
Been looking on yank sites seem cheap over there but getting here mite be a killer
Any photos would be great
Thanks Malcolm

I used to make plates that were flat under the spring and the sides were pressed upwards approx. 20mm ,then outwards approx. 20mm, 4 gussets on each side, they needed to be pressed to make they legal. If I knew how to put up photos I could show you. If your interested MP me.

I made up a set of theses , they were pretty easy to make and cheap to.