Offroad-Express

Having trouble finding a centre link for my 95 Sierra. Are the Sierras the same chassis as the samurais?

See if you can post a photo of it and I'll tell you what model it is.

Do you mean a picture of the part or whole car

Here's the Sierra

Here's the Sierra

Being a 95 and leaf sprung it is the same as a samurai .

What do you mean by centre link?

I believe it's called the centre link. It's the bar tha ties the front wheels together the tie rods attach to it and so does the drag link. I could be wrong

The tie rod joins the 2 wheels together and the drag link goes from the steering box (pitman arm) to the tie rod .

The rod ends ( ball joints ) on either end of the tie rod are replaceable . Only a bent tie rod or a worn out balljoint where the drag link attaches would require replacement of the entire tie rod.

Yea it's bent like a horse shoe so was hoping to find a 2nd hand one

is that redrocks mate

Yup red rocks

As UBZ said that is the same as a samurai, the chassis code is SJ70 to save any confusion as there is another model of samurai that is coil sprung and quite a bit different.

Any suggestions as to where I might be able to buy the part new

Unlikely to get a new one, as much as I hate to say it your best bet may be mudbits in Tauranga.

Yea I've tried them no luck. Suzuki said they could get them in but budget atleast 500$ what do people think about this http://www.ebay.com/ulk/itm/301740704780

Can you get it pressed straight-ish and then get it sleeved with a section of tube to strengthen it

I thought about putting it on my old mans press and trying to straighten it but it looks to be bent up but also backwards into the diff

you can try here

https://www.suzistore.com.au/four-wheel ... etail.html

Good guys deal with .