G16B idle issue - un burn fuel smell
Posted: Tue Apr 16, 2019 9:52 am
Hi all,
Please help!
Over the weekend I took the truck out and let it run about 10min and then took it for a drive. The truck had no issues at all but it was low on fuel but light wasn't indicating.
I took the car for a 10km drive on the motorway and it was all ok up until I came home and put to P. Car start stalling and it sounded like it's running on 3 cylinders.
But when I rev the engine it revs fine between 1000 - 3000RPM range and no stall or miss fire at all. as soon as release the paddle it is the same again.
No check engine light
takes time to start
What would be the cause? what should i check?
regards,
JC
Please help!
Over the weekend I took the truck out and let it run about 10min and then took it for a drive. The truck had no issues at all but it was low on fuel but light wasn't indicating.
I took the car for a 10km drive on the motorway and it was all ok up until I came home and put to P. Car start stalling and it sounded like it's running on 3 cylinders.
But when I rev the engine it revs fine between 1000 - 3000RPM range and no stall or miss fire at all. as soon as release the paddle it is the same again.
No check engine light
takes time to start
What would be the cause? what should i check?
regards,
JC