Page 1 of 1
Cost and where to go for body and spring lift?
Posted: Mon Mar 05, 2007 4:27 pm
by dannyboy4949
G'day again finally got a truck - 1990 v6 surf - and I stoked! Anyway I would really like to get a 2" spring lift and 2"body lift. As Im still learning I will get it done by a pro - but whats a good price? And where's a good honest place to go in Christchurch? Cheers
Dan
Posted: Mon Mar 05, 2007 4:31 pm
by pajeroboy
go to 4wd accessories on montreal st or delta 4wd on ferry road they both have good prices
Posted: Tue Mar 06, 2007 12:42 pm
by Aaron
Go straight to the people who make the springs, Chamberlains on sandyford st or Bellamy and East on Falsgrave st.
Posted: Tue Mar 06, 2007 1:32 pm
by wjw
4wdacc will have the blocks on the shelf I think... and yes chamberlains for the springs. They should have them on the shelf too.. my ones cost 200 a pair plus GST.. but I think I got a good deal
Posted: Tue Mar 06, 2007 5:32 pm
by dannyboy4949
wjw wrote:4wdacc will have the blocks on the shelf I think... and yes chamberlains for the springs. They should have them on the shelf too.. my ones cost 200 a pair plus GST.. but I think I got a good deal
So you boys would collect the necessary bits and then take it to one of the 4wd places? Or is there anywhere good to get the lift done?
Posted: Tue Mar 06, 2007 5:40 pm
by worzel
You can get it all done at 4wd acc if you want
Kev
Posted: Tue Mar 06, 2007 6:01 pm
by dannyboy4949
worzel wrote:You can get it all done at 4wd acc if you want
Kev
Thanks Kev will give them a call tomorrow - any rough idea of price??
Posted: Tue Mar 06, 2007 6:07 pm
by Sadam_Husain
I did my body lift myself, got the blocks off a guy on trademe and brought some 8.8 bolts, whole lot was just under $100 bucks.
Took about 2 hr's to do (only a cab and chassis). Had to loosen the steering shaft clamp and to let it slide out slightly when it came up, didn't have to worry about the fuel tank filler neck coz the tank is suspended from the body, brake and clutch lines stretched out their coils with the lift so they were ok, wiring loom and handbrake cable was ok. The 2 things I had to play around with were the transfer lever and the fan shroud, the transfer lever needed slight bending and adjusting so it cleared the floor ok and the fan shroud I dropped down 50mm and blanked the top and bottom 50mm's.
Posted: Wed Mar 07, 2007 7:24 am
by wjw
dannyboy4949 wrote:Thanks Kev will give them a call tomorrow - any rough idea of price??
Just call and speak to Rick, he's pretty busy though. 0800 4wdacc.
Posted: Wed Mar 07, 2007 11:39 am
by SupraLux
I have a large box full of 50mm blocks I had made up recently... haven't got around to buying the bolts yet to make up completed kits so if you want to buy blocks only and go get the bolts yourself (150 x M10 x G8.
give me a pm...
Steve
Posted: Sat Jul 14, 2007 12:16 am
by GotFlex
how much for your lifting blocks? in terms of difficulty how hard is it to do on a 92 nissan terrano?