Offroad-Express

Posted: **Wed Mar 21, 2007 7:11 pm**

One of my swivel hubs leaks a little bit of grease, how much do i fill it up? in the manual it says fill to sufficent level, but what the is the sufficent level?

Posted: **Wed Mar 21, 2007 11:05 pm**

Drill out and tap a 1/8"BSP thread into the filler plug, fit a grease nipple, then pump a full cartridge of grease into each side.

Posted: **Wed Mar 21, 2007 11:08 pm**

Probly find ,if grease is coming out, then the inner axle seal need looking at.

Posted: **Wed Mar 21, 2007 11:10 pm**

If its leaking grease out it must be leaking water in.... best top pull them apart down to check them and replace the seals

Posted: **Thu Mar 22, 2007 12:42 pm**

If you pull them apart and the grease is molke replace it but you will go through about 3 - 5 tubes to do both sides :shock:

Fill them as full as you can it helps keep the water out and greases the top pinion bearing too.

Posted: **Thu Mar 22, 2007 5:28 pm**

cheers guys, any ideas where abouts i can get the seals around the chch area? or online

Posted: **Thu Mar 22, 2007 6:08 pm**

Talk to Steve "supraLux" he sells the Max trac stuff get a kit.... all the gaskets seals and new kingpin bearings for a good price

Cheers Reece

Posted: **Fri Mar 23, 2007 8:39 pm**

I'm not really selling any more Reece, but thanks for the plug. Don't have time with a new project I'm working on - trying to distance myself from anything but my own project truck and get it ready for sometime before next year

If you're stuck for one I can get you one for $140 and can also show ya roughly how it all goes together... I do have one left tucked under my bench for emergencies...

Steve

Offroad-Express

swivel hubs?

swivel hubs?