Wanted Toyota 30 spline Drive Flanges

suzolla · Post by **suzolla** » Thu May 03, 2007 4:51 pm

Hi, I'm looking for some hub drive flanges that will go on a Hilux 30 spline CV, want to replace freewheel hubs to make it fixed drive. Does anyone know if the ones on the VX cruisers will fit as I imagine there are a few around that have had them replaced with freewheel hubs.
Thanks Tim

oldblue · Post by **oldblue** » Thu May 03, 2007 5:58 pm

Im pretty sure that I have a couple of sets in the shed, will look tomorrow, if your still interested.

oldblue · Post by **oldblue** » Thu May 03, 2007 6:00 pm

These are off 70s cruisers

suzolla · Post by **suzolla** » Thu May 03, 2007 9:54 pm

Sounds great
Thanks
Tim

oldblue · Post by **oldblue** » Fri May 04, 2007 9:09 am

Found a set of driveing flange's, were for 30 spline longer type axle, I have machined them to the short axle type, the end cap on one is a wee bit loose, but a bit of sealer will hold it OK.
I'll be away with the Nelson Club in Reefton till Monday, so can't view any of this topic till Monday night.