Driveshaft slipjoint regreasing
Posted: Tue May 15, 2007 9:39 pm
I have both driveshafts out at the moment to do the clutch.
I want to regrease the slip joints. I assume it's important to retain the current alignment on each shaft.
Do I clean them up and apply a small amount of grease to the spline section?
Cheers
Matt.
I want to regrease the slip joints. I assume it's important to retain the current alignment on each shaft.
Do I clean them up and apply a small amount of grease to the spline section?
Cheers
Matt.
