Page 1 of 1
PTO Winch WANTED
Posted: Mon Jul 30, 2007 8:46 pm
by Beer_Cruiser
WANTED PTO WINCH for 70 series Toyota
Have seen a 60 series on TM. Would it fit?
Whats the deal with the gears?
Re: PTO Winch WANTED
Posted: Mon Jul 30, 2007 9:12 pm
by skid
Beer_Cruiser wrote:WANTED PTO WINCH for 70 series Toyota
Have seen a 60 series on TM. Would it fit?
Whats the deal with the gears?
look back thru other posts about winches or PM Wopass, hes the toyota PTO winch expert
Posted: Mon Jul 30, 2007 10:06 pm
by Sadam_Husain
Got a complete one but I'm not letting go of it. You'll have to make sure that you get the right PTO for your split transfercase and you'll have to check that you have the drive gear in your transfercase, some do and some just have a spacer on the shaft where the drive gear goes.
Might need to have a look at where your exhaust runs if its on the passenger side of the truck
Posted: Mon Jul 30, 2007 10:27 pm
by monstr
Hi Check out trade me auct no 111433736 A complete pto for a 70 ...Cheers
Posted: Mon Jul 30, 2007 10:32 pm
by Beer_Cruiser
if i take square cover off transfercase will i be able to see if ive got drive gear? wot am i looking for.
is it hard to get drive gear in t/c? i have enuff knowledge to be dangerous
Posted: Mon Jul 30, 2007 10:49 pm
by Sadam_Husain
if you take the PTO blanking plate off you'll be looking at the output shaft, the PTO drive gear is a square cut gear towards the rear of the shaft, if its not there the shaft will just have a spacer like a tube in its place to hold the other helical gears in place. My 70# dosent have one but I've got a spare 40# transfer case that has one in it.
It's not a major to split the transfercase to put the drive gear in :drunken:
Posted: Tue Jul 31, 2007 6:08 am
by Beer_Cruiser
thanks for your help. will have a look tonight after work
Posted: Tue Jul 31, 2007 8:47 am
by Sadam_Husain
the picture stolen from some internet site shows the PTO drive gear on the end of the shaft, its not easy to see through the side of the t/c still in the truck but you should be able to work out if its there or not
Posted: Tue Jul 31, 2007 8:18 pm
by Beer_Cruiser
had a look tonight can see what looks like pto drive gears on the shaft at the rear end of the t/c between these gears and next lot of gears theres small spacer maybe 50mm. these gears are intermeshing while the gears at the back of the t/c (pto drive gears?) do not seem to meet.
sorry about the flash terminology this is all pretty new to me.thanks for the pic i think thats what i was looking at. didnt have camera or would have taken pic.
Posted: Wed Aug 01, 2007 12:02 pm
by Beer_Cruiser
does enyone know if a 60series pto winch will fit my 70.there seems to be a shit load of them around
Posted: Wed Aug 01, 2007 1:39 pm
by sig
the winchs are the same but the mounting brackets are different and the driveshaft lenght will be different as well
Posted: Wed Aug 01, 2007 4:18 pm
by Beer_Cruiser
thanks for help will keep that in mind