Page 1 of 1
where to find locker for gen1 pajero
Posted: Wed Sep 05, 2007 9:29 am
by slow200sx
i have two pajeros one is an f0 and one is a f1 , both are first generation pajeros, both with 2.5dt manual, one has leaf srings in rear and one has coils, i need to find lockers or lsd units for the rear of both, what fits in them? and out of what vehicles? they are 1988 and 1989 year cars that i have.
if you have an lsd that will fit txt me on 0211212182
Posted: Wed Sep 05, 2007 2:22 pm
by tgaguy1
I can do you a NZ new, LWB, gen 2, 1993, 2.5 diesel manual with factory diff lock (5.286 ratio) for $1300 complete truck. The motor is tired, down to 200 psi in all cylinders but the rest is fine, just a bit dirty.
That way you can put the diff lock and the springs in your coiled gen 1, and if you put the front diff in you would have super select.
Truck is located in Tauranga.
Let me know soon before I re-engine as I will want more once it is Wof reg'ed.
Posted: Wed Sep 05, 2007 4:44 pm
by NJV6
It'll take alot of work to get the super select into the Gen 1 as the transfer cases are different.
I think ARB do a diff lock for the back but that is more than your vehicle is worth
You NEED to find a locker or LSD? Gen 2 axles are wider. But to swap the rear like taguy mentioned would be the best wayto get a locker. But you'd have to make sure the front was the same ratio as the 5.29 your putting in was.
NJ
Posted: Wed Sep 05, 2007 5:57 pm
by slow200sx
I AM AFTER A LSD
Re: where to find locker for gen1 pajero
Posted: Wed Sep 05, 2007 6:05 pm
by NJV6
slow200sx wrote: i need to find lockers or lsd units
(then)
I AM AFTER A LSD
OK THATS FINE & GOOD LUCK
Turn your caps lock off too, ITS SHOUTING
NJ